Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the charge air cooler, condenser, fan, and radiator assembly. Charge Air Cooler, Condenser, Fan Motor, and Radiator Assembly Removal and Installation (LM2)
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Outlet Front Duct Clamp (1) - Loosen [2x]
Air Cleaner Outlet Front Duct (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Nut (2) - Remove
Disconnect the 2 electrical connectors (5) from the mass air flow sensor and the air cleaner.
Remove all wiring harness retainers from the air cleaner.
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Housing Cover Bolt (1) - Remove [3x]
Air Cleaner Upper Housing (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Cleaner Lower Housing (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Radiator Inlet Hose Clip (1) - Disengage
Engine Wiring Harness Retainer (2) - Remove [2x]
Engine Wiring Harness Bracket Bolt (3) - Remove
Engine Wiring Harness Bracket (4) - Remove
Courtesy of GENERAL MOTORS COMPANY

Electrical Connector (1) - Disconnect
Courtesy of GENERAL MOTORS COMPANY

Battery Positive Cable Nut (1) @Generator - Remove
Generator Battery Jumper Cable (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Engine Front Cover Bolt (1) - Remove
Engine Front Cover (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Rotate the accessory drive primary belt tensioner (1) clockwise to release the drive belt tension.
Slide the accessory drive primary belt (2) off of the belt idler pulley and slowly release the accessory drive primary belt tensioner (1).
Remove the accessory drive primary belt (2).
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Bracket Nut (1) - Remove [2x]
Engine Wiring Harness Bracket Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Engine Wiring Harness Ground Bolt (1) - Remove
Ground Cable (2) - Position aside
Disconnect electrical connectors as needed, detach retainer at intake manifold and reposition the engine wiring harness channel (3) away from the front of the engine.
Courtesy of GENERAL MOTORS COMPANY

Generator Bolt (1) - Loosen until disengaged
Generator Bolt (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Generator (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Conditioning Compressor Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Conditioning Compressor Bolt (1) - Remove
Courtesy of GENERAL MOTORS COMPANY

Air Conditioning Compressor Nut (1) - Remove
Air Conditioning Compressor Stud (2) - Remove
Reposition the air conditioning compressor, as needed.
Courtesy of GENERAL MOTORS COMPANY

Drive Belt Idler Pulley (4) - Remove
Drive Belt Tensioner Bolt (1) - Remove
Drive Belt Tensioner (2) - Remove
Courtesy of GENERAL MOTORS COMPANY

Generator and Air Conditioning Compressor Bracket Bolt (2) - Remove [4x]
Generator and Air Conditioning Compressor Bracket (1) - Remove