Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Clean all sealing surfaces.
- NOTE:
- Install and align the crankshaft front oil seal to the block within 10 minutes after applying the sealer.
- Ensure proper use of room temperature vulcanizing (RTV) sealant.
Apply a 4.0 mm (0.157 in) bead of sealer along the crankshaft front oil seal sealing path (1), dimension a. Increase the bead to 6.0 mm (0.236 in) at the two locations b. Adhesives, Fluids, Lubricants, and Sealers
Install the EN-52452 Front Crankshaft Seal Installer (1) to the crankshaft.
- Install and hand tighten the 2 bolts (2) of the EN-52452 Front Crankshaft Seal Installer (1).
Crankshaft Front Oil Seal (1) - Install NEW
- Check that the crankshaft front oil seal (1) sits correctly on the crankshaft and the 2 pins (2, 4).
- Remove the 2 bolts (5) from the EN-52452 Front Crankshaft Seal Installer (3).
- Remove the EN-52452 Front Crankshaft Seal Installer (3) from the crankshaft.
Engine Front Cover Bolt (1) - Install and tighten in sequence [8x] - Fastener Specifications
Crankshaft Pulley (1) - Install
- Crankshaft Pulley Bolt (2) - Install and hand tighten [4x]
Install the EN-49979 Crankshaft Holder (1) with EN-956-1 Extension (3) to the crankshaft pulley.
- Crankshaft Pulley Bolt (2) - Tighten [4x] - Fastener Specifications
- Remove the EN-49979 Crankshaft Holder (1) with EN-956-1 Extension (3) to the crankshaft pulley.
Install the accessory drive primary belt (2) to the vehicle.
- Rotate the accessory drive primary belt tensioner (1) clockwise.
- Install the accessory drive primary belt (2) around all pulleys.
Engine Front Cover (2) - Install
- Engine Front Cover Bolt (1) - Install and tighten - Fastener Specifications
- Install the charge air cooler, condenser, fan and radiator assembly to the vehicle. Charge Air Cooler, Condenser, Fan Motor, and Radiator Assembly Removal and Installation (LM2)
- Check and correct the engine oil level.
NOTE:
Ensure the proper routing of the accessory drive primary belt.