Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Courtesy of GENERAL MOTORS COMPANY

Install the accessory drive primary belt (2) to the vehicle.
Rotate the accessory drive primary belt tensioner (1) clockwise.

NOTE:

Ensure the proper routing of the accessory drive primary belt.

Install the accessory drive primary belt (2) around all pulleys.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Engine Front Cover (2) - Install

Courtesy of GENERAL MOTORS COMPANY

{without RC1} Install the front bumper fascia extension.

NOTE:

Quantity of fasteners may vary based on option content.

Front Bumper Fascia Extension (4) - Install

CAUTION:

Refer to Fastener Caution .

Front Bumper Fascia Extension Bolt (3) @Underbody Skid Shield - Install and tighten [2x] - Fastener Specifications
Front Bumper Fascia Extension Bolt (2) - Install and tighten [4x] - Fastener Specifications

Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Extension (1) - Install

Courtesy of GENERAL MOTORS COMPANY

Front Bumper Fascia Extension Bolt (2) - Install and tighten [8x] - Fastener Specifications

Front Bumper Fascia Air Deflector Bolt (1) - Install and tighten [10x] - Fastener Specifications

Courtesy of GENERAL MOTORS COMPANY

{with RC1} Install the underbody splash shield.

Underbody Splash Shield (1) - Install

Courtesy of GENERAL MOTORS COMPANY

Underbody Splash Shield Bolt (2) - Install and tighten [4x] - Fastener Specifications

Front Bumper Fascia Skid Plate Bolt (1) - Install and tighten [4x] - Fastener Specifications

Lower the vehicle.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Push down and rearward on the engine front cover (2) to engage the 5 retaining grommets to the ball studs.
Engine Front Cover Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Left side shown, right side similar.

Front End Sheet Metal Diagonal Brace- Left Side and Right Side (2) - Install [2x]
If NEW threaded components are being installed, loosen the adhesive using a metal pick or similar tool before proceeding. If threaded components are reused, prepare the threaded components using the following steps:
1. Remove any loose cured adhesive from the external threads of the components using a lint free cloth.
2. Thread the cleaned components into the internal mating threads and remove to loosen trapped cured adhesive.
3. Apply thread locking adhesive to the external threads of the components. Adhesives, Fluids, Lubricants, and Sealers
4. Ensure there are no gaps in the thread locking adhesive once applied to the component.
Front End Sheet Metal Diagonal Brace Bolt- Left Side and Right Side (1) - Install and tighten [4x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Intake Air Splash Shield (2) - Install
Intake Air Baffle Retainer (1) - Install [9x]
Courtesy of GENERAL MOTORS COMPANY

{ If equipped }Hood Secondary Latch Release Handle (2) - Install
{ If equipped }Hood Latch Actuator Bolt (1) - Install and tighten [2x] - Fastener Specifications
Oil Filler Cap - Remove
Courtesy of GENERAL MOTORS COMPANY

Intake Manifold Cover (2) - Install
Intake Manifold Cover Bolt (1) - Install and tighten - Fastener Specifications
Oil Filler Cap - Install