Conditions for Setting the DTC
WARNING: This page is about a different variant/trim than selected.
P261F
Auxiliary Coolant Pump = Commanded state does not match the actual state - For greater than 8 s
P2B86, P2B87
Auxiliary Coolant Pump Speed = Not within a calibrated range - For greater than 8 s
P3077, P3078
Auxiliary Coolant Pump Speed = Not within a calibrated range - For greater than 4 s
U0623
Serial Data circuit = Communication Failed - For greater than 2.5 s
U137E
Serial Data circuit = Message Counter Incorrect - Control module that has set the DTC
The above condition(s) must occur 3 times.