Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition - On/Vehicle - In Service Mode
- Verify DTC P0422, P244C, P24A0 is not set.
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Verify there are no DTCs set related to the following component/system:
- B17 Barometric Pressure Sensor
- B34 Engine Coolant Temperature Sensor
- B65 Intake Manifold Pressure and Air Temperature Sensor
- B75C Multifunction Intake Air Sensor
- B130 Exhaust Gas Recirculation Temperature Sensor
- B131 Exhaust Temperature Sensor
- B154 Diesel Particulate Filter Exhaust Differential Pressure Sensor
- Q14 Exhaust Gas Recirculation Valve
- Q17 Fuel Injector
- Q22 Intake Manifold Tuning Solenoid Valve
- If a related DTC is set
- Go to next step: If a related DTC is not set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.