LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 3.0L (Lm2) Diesel - Diagnostic Information And Procedures (5 Of 5)) >> Diagnostic Information and Procedures >> DTC P2453 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following component/system:
    • B75C Multifunction Intake Air Sensor
    • B131 Exhaust Temperature Sensor
    • Go to next step: If a related DTC is not set 
  3. Engine idling.
  4. Verify the scan tool DPF differential pressure parameter is within 0 - 10 kPa (0 - 1.5 PSI).
    • If not within 0 - 10 kPa (0 - 1.5 PSI) 

      Refer to Circuit/System Testing.

    • Go to next step: If within 0 - 10 kPa (0 - 1.5 PSI) 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  6. Verify that the DTC is not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • Go to next step: If the DTC does not set 
  7. All OK.
scientia non olet · About LEMON Manuals