Cleaning Procedure
WARNING:
Refer to Safety Glasses Warning .
NOTE:
- When cleaning a cylinder head in a thermal type oven, do Not exceed 204°C (400°F).
- Be careful not to scuff the chamber.
Clean the following components:
- Combustion Chamber
Use the EN-8089 Carbon Removal Brush to remove the carbon from the combustion chambers.
- Fuel Injector Bores
Use the EN-47909 Injector Bore Brush Kit to remove the carbon from the fuel injector bores.
- Gasket surfaces
- Remove all gasket and sealing material from the part using J-28410 gasket remover or equivalent.
- Care must be used to avoid gouging or scraping the sealing surfaces.
- Do not use any other method or technique to remove sealant or gasket material from a part.
- Do not use abrasive pads, sand paper, or power tools to clean the gasket surfaces.
- Valve stems and heads on a buffing wheel
- Bolt hole threads
Remove all dirt, debris, or threadlocking material from the bolt holes.