Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

CAUTION:
Refer to Fastener Caution .

Valve Rocker Arm Cover Insulator Retainer (1) - Install and tighten [3x] - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Valve Rocker Arm Cover Gasket (2) @Valve Rocker Arm Cover (1) - Install NEW
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Some components not shown for graphic clarity.

Valve Rocker Arm Cover- Right Side (2) - Install
Valve Rocker Arm Cover Bolt (1) - Hand tighten [10x]
Valve Rocker Arm Cover Bolt (1) - Tighten in sequence [10x] - Fastener Specifications
Engine Wiring Harness Connector@Ignition Coil - Connect [4x]
Courtesy of GENERAL MOTORS COMPANY

Inspect the inside of the spark plug rubber boot for a thin even coat of grease. If there is no grease present or additional grease is necessary, apply a thin coating of dielectric grease evenly to the inside of the spark plug rubber boot up to a depth of 15 mm from the end of the boot. Adhesives, Fluids, Lubricants, and Sealers
Push the 4 spark plug wire boots (1) onto the 4 ignition coils (2) until two audible clicks are heard.
Courtesy of GENERAL MOTORS COMPANY

Heater Inlet and Outlet Hose Bracket (2) - Reposition
Heater Hose Clip Bracket Bolt (1) - Install and tighten - Fastener Specifications
Courtesy of GENERAL MOTORS COMPANY

Valve Rocker Arm Cover Insulator (3) - Install
Install the 3 upper intake manifold sight shield grommets (1) to the 3 valve rocker arm cover insulator retainers (2).
Courtesy of GENERAL MOTORS COMPANY

Positive Crankcase Ventilation Tube Connector (3) @Positive Crankcase Ventilation Fitting - Install - Plastic Collar Quick Connect Fitting Service