LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Liftgate Replacement (with TC2) >> Installation Procedure

Installation Procedure

  1. GM5581804Courtesy of GENERAL MOTORS COMPANY

    With the aid of an assistant, install the liftgate. (2)

    2. CAUTION:

    Refer to Fastener Caution .

  2. Liftgate Hinge Bolt (1) - Install and tighten [4x] - Fastener Specifications 
  3. GM5582168Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the clip is fully seated when the rod is reinstalled. If the clip cannot be fully seated, a new rod should be installed.

    Liftgate Power Assist Actuator (1) - Install

  4. Install the 2 metal clips to each end of the liftgate power assist actuator (1).
  5. GM5581806Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure the clip is fully seated when the rod is reinstalled. If the clip cannot be fully seated, a new rod should be installed.

    Liftgate Strut (1) - Install

  6. Install the 2 metal clips at each end of the liftgate strut (1).
  7. GM5645504Courtesy of GENERAL MOTORS COMPANY

    Connect the washer hose and electrical connector and retainers..

  8. Liftgate Wiring Harness Grommet (2) - Install
  9. Washer Hose Grommet (1) - Install
  10. GM5582514Courtesy of GENERAL MOTORS COMPANY

    Liftgate Weatherstrip (1) - Install

scientia non olet · About LEMON Manuals