LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Tahoe SSV >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Primary and Secondary Latch Replacement >> Installation Procedure

Installation Procedure

  1. GM5573765Courtesy of GENERAL MOTORS COMPANY

    Hood Primary Latch Release Cable (3) - Install

  2. Connect the electrical connector.
  3. Install the wire harness retainer to the upper tie bar.
  4. Hood Primary and Secondary Latch (2) - Install
    5. CAUTION:

    Refer to Fastener Caution .

  5. Hood Primary and Secondary Latch Bolt (1) - Install and tighten [2x] - Fastener Specifications 
  6. GM5541784Courtesy of GENERAL MOTORS COMPANY

    Intake Air Splash Shield (2) - Install

  7. Intake Air Baffle Retainer (1) - Install [9x]
  8. GM5541781Courtesy of GENERAL MOTORS COMPANY

    Hood Secondary Latch Release Handle (2) - Install

  9. Hood Latch Actuator Bolt (1) - Install and tighten [2x] - Fastener Specifications 
scientia non olet · About LEMON Manuals