Removal Procedure
Hood Latch Actuator Bolt (1) - Remove [2x]
- Hood Secondary Latch Release Handle (2) - Remove
Intake Air Baffle Retainer (1) - Remove [9x]
- Intake Air Splash Shield (2) - Remove
Hood Primary and Secondary Latch Bolt (1) - Remove [2x]
- Hood Primary and Secondary Latch (2) - Remove
- Disconnect the hood primary latch release cable (3) from the hood primary latch.
- Release the retainer under the tie bar and disconnect the electrical connector.
Reposition the hood primary latch release cable (1) from the upper tie bar.
Front Bumper Fascia (2) - Remove - Front Bumper Fascia Removal and Installation (without Front Fascia Extension) , or Front Bumper Fascia Removal and Installation (with Front Fascia Extension)
Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]
Headlamp Bolt- Left Side and Right Side (1) - Remove [6x]
Release the front headlamp guide pin from the front bumper fascia guide (1).
- Front Headlamp- Left Side and Right Side (2) - Remove [2x]
- Release the wiring harness retaining tab
- Disconnect all electrical connectors.
Loosen the left and right side front bumper fascia upper stiffener nut (1).
- Remove the left and right side front bumper fascia upper stiffener bolt (2).
Pull the front bumper fascia upper stiffener (1) up and out over the stud.
Ambient Air Temperature Sensor (1) - Remove
- Disconnect the electrical connector. (2)
Front Bumper Shutter Retainer (1) - Remove [3x]
Front Bumper Shutter Bolt (1) - Remove [9x]
- Front Bumper Shutter (2) - Remove
Front Grille Support Bracket Bolt (1) - Remove [4x]
- Front Grille Support Reinforcement (2) - Remove
Front End Upper Tie Bar Bolt (1) @Headlamp Bracket - Remove [8x]
- Headlamp Bracket (2) - Remove [2x]
Intake Air Duct Retainer (1) - Remove
- Intake Air Duct (2) - Remove
Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [4x]
- Front End Sheet Metal Diagonal Brace@Radiator (2) - Remove [2x]
Front End Sheet Metal Diagonal Brace Bolt (1) - Remove [4x]
- Front End Sheet Metal Diagonal Brace@Upper Tie Bar (2) - Remove [2x]
Radiator Air Upper Baffle (1) - Remove
Horn Nut (1) - Remove
- Dual Horn (2) - Remove
- Disconnect the electrical connector.
Front End Upper Tie Bar Bolt (1) - Remove [3x]
- Front End Upper Tie Bar Bolt (1) - Remove
Front End Upper Tie Bar Bolt (1) - Remove [3x]
Front End Upper Tie Bar Bolt (1) - Remove
- Disconnect the wiring harness retainers and reposition the harness as necessary.
Front End Upper Tie Bar (1) - Remove