Removal Procedure

Courtesy of GENERAL MOTORS COMPANY

Using the appropriate trim tool, remove both windshield wiper arm finish caps (1) from the windshield wiper arms (3).
Windshield Wiper Arm Nut (2) - Remove [2x]
Use the J - 39822 Wiper Arm Puller to remove the wiper arm (3) from the wiper motor pivot shaft.
Courtesy of GENERAL MOTORS COMPANY

NOTE:
Quantity of retainers may vary based on option content.

Apply two layers of masking tape to the painted surface around the top edge of the air inlet grille panel extensions (1) to prevent paint damage.
Using a suitable plastic trim tool, carefully release the air inlet grille panel extension clips.
Air Inlet Grille Panel Extension (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Hood Rear Outer Air Inlet Seal Retainers (1) - Remove [2x]
Hood Rear Outer Air Inlet Seal (2) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Air Inlet Grille Panel Retainer (1) - Remove [8x]
Windshield Washer Nozzle Hose - Disconnect [3x]
Lift the front edge of the air inlet grille panel (2) and slide the panel forward from both hood hinges to remove.
Courtesy of GENERAL MOTORS COMPANY

Windshield Wiper System Module Shield (1) - Remove

NOTE:

To prevent erroneous DTC's, disconnect the battery negative cable before disconnecting the windshield wiper motor electrical connector.

Disconnect the battery negative cable. Battery Negative Cable Disconnection and Connection (9C1, 5W4) , or Battery Negative Cable Disconnection and Connection (KL9)
Courtesy of GENERAL MOTORS COMPANY

Release the retainers.
Windshield Wiper System Module Bolt (1) - Remove [2x]
Slide the windshield wiper system module (2) inboard to release the grommet from the plenum and flip the windshield wiper system module upside down to gain access to the electrical connector.
Push electrical connector together to unload the latch system. Then using a small pick or small flat bladed tool, lightly pry down and outboard on the locking tab (3) and pull the electrical connector away from the module mating connector. Do NOT attempt to pry anywhere else on the connector body or damage can occur.
Verify the electrical connector and the windshield wiper system module mating connector (3) are not damaged.
Courtesy of GENERAL MOTORS COMPANY

Dash Panel Outer Insulator Retainer (1) - Remove [3x]
Radiator Surge Tank Bolt (2) - Remove
Radiator Surge Tank (3) - Reposition
Courtesy of GENERAL MOTORS COMPANY

Dash Panel Outer Insulator Retainer (1) - Remove [2x]
Courtesy of GENERAL MOTORS COMPANY

Pull the dash panel outer insulator - upper (1) forward and upward to remove.