Removal Procedure
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Fuse Block Access Hole Cover(1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Trim Plate Applique(1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Center Trim Plate Applique(1) - Remove
Instrument Panel Upper Trim Panel Bolt(1) - Remove[6x]
- Using a flat-bladed plastic trim tool, release the retaining clips.
- Disconnect the electrical connector.
- Instrument Panel Trim Pad(2) - Remove
Instrument Panel Lower Trim Panel Outer Filler(1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Fuse Block Access Hole Cover(1) - Remove
Using a flat-bladed plastic trim tool, release the retaining clips.
- Instrument Panel Trim Plate Applique(1) - Remove
Instrument Panel Trim Pad Bolt(1) - Remove[2x]
- Disconnect the electrical connectors.
- Instrument Panel Trim Pad(2) - Remove
- Extend the steering column to its furthest point to allow the instrument panel steering column upper trim cover to clear the instrument panel.
Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column lower trim cover.
Using a small plastic trim tool, separate the instrument panel steering column upper trim cover (1) from the instrument panel steering column opening closeout (2).
Instrument Panel Center Trim Panel Bolt(1) - Remove[6x]
- Disconnect the electrical connectors.
- Instrument Panel Transmission Shift Opening Cover(2) - Remove
Instrument Panel Cluster Trim Plate Bolt(1) - Remove[4x]
- NOTE:
Use a plastic trim tool if necessary.
Instrument Panel Cluster Trim Plate(1) - Remove
Instrument Cluster Bolt(1) - Remove[4x]
- Disconnect the electrical connectors.
- Instrument Cluster(2) - Remove
Use care not to bend or deform the thin area of the instrument panel trim pad.