Installation Procedure
Head-Up Display Bracket(2) - Install
- Connect and position the wiring harness.
- Head-Up Display Bracket Bolt(1) - Install and tighten[3x] - Fastener Specifications
Connect the electrical connector.
- Head-Up Display(2) - Install
- Head-Up Display Bolt(1) - Install and tighten[4x] - Fastener Specifications
Instrument Panel Upper Trim Panel(1) - Install - Instrument Panel Upper Trim Panel Removal and Installation
- Enable the SIR System. SIR Disabling and Enabling
CAUTION:
Refer to Fastener Caution .
NOTE:
Ensure that each tab on the head-up display is properly seated in the mating hole for proper alignment.