Wheel Seal: Remove & Replace
WARNING: This page is about the Silverado 1500 Custom, 4D Pickup Crew Cab, 4WD, which is a different variant/trim than selected.
Includes: Repack and adjust Bearings (where applicable).| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Rear Axle,Both | 4.2 | B | ||
| Rear Axle,One Side | 3.1 | B | ||
| Combination Procedure: BRAKE PAD LIFE MONITORING SYSTEM: Reset: | ||||
| Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | ||
| Combination Procedure: BRAKE PAD WEAR SENSOR: Replace: | ||||
| Rear,One | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing or correction plate. | 0.2 | B | |
| Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable: | ||||
| Parking Brake Service Mode | Includes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls. Includes: Electronic Parking Brake System Calibration. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: OIL SEAL WEAR SLEEVE: Replace: | ||||
| Rear Axle,Each | 0.2 | B | ||
| Combination Procedure: PARKING BRAKE: Calibrate: | ||||
| Includes: Additional time for use of scan tool to perform this procedure. | 0.2 | B | ||