Heater and Air Conditioning Remote Control Replacement

Courtesy of GENERAL MOTORS COMPANY

NOTE: Callouts items in the following chart represent components shown in graphic above.

Callout	Component Name
1	Heater and Air Conditioning Remote Control Procedure Disconnect the heater and air conditioning remote control connectors. Release the retaining tabs. Perform the HVAC system control module programming and setup procedure. Control Module References Clear all trouble codes. NOTE: When removing the multiuse module bracket for any reason, it is required that the connector to the heater and air conditioning remote control be disconnected. If the vehicle battery has NOT been disconnected, when reinstalling or reconnecting the remote control, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the heater and air conditioning remote control.

Callout

Component Name

Heater and Air Conditioning Remote Control

Procedure

Disconnect the heater and air conditioning remote control connectors.
Release the retaining tabs.
Perform the HVAC system control module programming and setup procedure.
Control Module References
Clear all trouble codes.

NOTE:

When removing the multiuse module bracket for any reason, it is required that the connector to the heater and air conditioning remote control be disconnected. If the vehicle battery has NOT been disconnected, when reinstalling or reconnecting the remote control, the BROWN J2 connector must be connected last. Once all the parts are all in place, check and clear all DTCs in the heater and air conditioning remote control.