Stator Shaft Support Assembly
WARNING: This page is about a different variant/trim than selected.
NOTE:
Callouts in the following chart represent components shown in graphic above.
| Callout | Component Name |
|---|---|
| 84 | Automatic Transmission Case Front Cover |
| 398 | Automatic Transmission Case Cover Retaining Ring |
| 401 | Automatic Transmission Case Front Cover Bolt |
| 403 | Automatic Transmission Fluid Pump Drive Gear |
| 404 | Torque Converter Fluid Seal |
| 407 | Stator Shaft Support |
| 408 | Stator Shaft Support Seal |
| 409 | 1-2-3-4-5-6-Reverse Clutch Piston Seal- Inner |
| 410 | 1-2-3-4-5-6-Reverse Clutch Piston Seal- Outer |
| 411 | 1-2-3-4-5-6-Reverse Clutch Piston |
| 412 | 1-2-3-4-5-6-Reverse Clutch Piston Return Spring |
| 413 | 1-2-3-4-5-6 Clutch Spring Retaining Ring |
| 414 | 1-2-8-9-10-Reverse Clutch Piston |
| 415 | 1-2-8-9-10-Reverse Clutch Apply Plate |
| 416 | 1-2-8-9-10-Reverse Clutch Piston Return Spring |
| 417 | 1-2-8-9-10-Reverse Fiber Clutch Plate |
| 418 | 1-2-8-9-10-Reverse Steel Clutch Plate |
| 419 | 1-2-8-9-10-Reverse Clutch Backing Plate |
| 420 | 1-2-8-9-10-Reverse Clutch Backing Plate Retaining Ring |
| 421 | Low Clutch Roller |
| 422 | Center Support Thrust Washer |