LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Engine Mechanical - 2.0L - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Driveline Mount Actuator Malfunction >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.

Dynamic Test

  1. Disconnect the harness connector at the appropriate Engine Mount Solenoid Valve.
  2. Install a 10A fused jumper wire between the ignition terminal 2 and 12 V. Install a jumper wire between the control terminal 1 and ground.
  3. Verify the appropriate Engine Mount Solenoid Valve turns on and off or clicks.
    • If the Engine Mount Solenoid Valve does not turn on and off or click. 

      Replace the appropriate Engine Mount Solenoid Valve.

    • Go to next step: If the Engine Mount Solenoid Valve does turn on and off or click. 
  4. All OK
scientia non olet · About LEMON Manuals