Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- DTC P0111, P0112, P0113, P0114, P0117, P0118, P0128, P0502, P0503, P0601, P1621, P2610 = Not set
- If any of the DTCs are set
- Go to next step: If none of the DTCs are set
- Engine Off Time = For greater than 8 h
- Ignition - On/Vehicle - In Service Mode
- Verify the following parameters are within 15.8°C (28.4°F) of each other:
- Ambient Air Temperature Sensor
- ECT Sensor
- IAT Sensor 1
- If not within 15.8°C (28.4°F) of each other
{Ambient Air Temperature Sensor} Refer to: DTC P0071-P0074
{ECT Sensor} Refer to: DTC P0116-P0119
{IAT Sensor 1} Refer to: DTC P0112-P0114
- Go to next step: If within 15.8°C (28.4°F) of each other
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
Refer to: Circuit/System Testing
- Go to next step: If the DTC is not set
- If the DTC sets
- All OK.