TCC Slip Control Test
WARNING: This page is about a different variant/trim than selected.
- Utilize TIS2Web/GDS2/MDI service tool
- Select module diagnostics - TCM
- Select TCC data for session log/data collection
- Collect data between 89 and 113 km/h (55 and 70 mph) steady state/steady throttle with minimum 15 seconds
- For line graph evaluation, set parameter minimum and maximum to values stated for comparison: See Figure 1
- Evaluate collected data with line graphs and compare data to each figure below:
- Normal State: See Figure 2
- Degraded State: See Figure 3
- Damaged State: See Figure 4
Figure 1: Parameter Minimum and Maximum Values
Figure 2: Parameter Normal Test Result
Figure 3: Parameter Degraded Test Result
Figure 4: Parameter Damaged Test Result