Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
NOTE:
- DTC P2817 will set with a hydraulic/mechanical condition.
- DTC P2818 will set with a hydraulic/mechanical condition or high resistance in the circuit of the component Q77H without setting component/control circuit DTCs.
- The components are listed from the least to the most intrusive to service.
- Verify the conditions listed in the table do not exist
| Component | DTC | Condition |
|---|---|---|
| Q77H Transmission Control Solenoid Valve 8 | P2817, P2818 |
|
| DefaultValve | P2817, P2818 |
|