Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
NOTE:
- DTC P2808 will set with a hydraulic/mechanical condition.
- DTC P2809 will set with a hydraulic/mechanical condition or high resistance in the circuit of the component Q77G without setting component/control circuit DTCs.
- The components are listed from the least to the most intrusive to service.
- Verify the conditions listed in the table do not exist
| Component | DTC | Condition |
|---|---|---|
| Q77G Transmission Control Solenoid Valve 7 | P2808, P2809 |
|
| Torque Converter Clutch Regulator Valve | P2808, P2809 |
|
| Torque Converter Clutch Control Valve | P2808, P2809 |
|
| Torque Converter | P2808, P2809 |
|