Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure is required when the following component has been repaired, replaced, removed, or serviced:

Ignition - On/Vehicle - In Service Mode
Verify DTC P27A7, P27A8, P27A9, P27AA, P27AB, P27AC, P27AD is not set.
- If any of the DTCs are set
  Refer to: Q77 Transmission Control Solenoid Valve Characterization Programming (8L45) , or Q77 Transmission Control Solenoid Valve Characterization Programming (10L60, 10L80 or 10L90)
- Go to next step: If no DTC is set
All OK.