Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
| Circuit |
Description |
| 9 V Reference |
Regulated voltage supplied by the control module. |
| Signal |
The sensor produces a PWM signal. |
| Component |
Description |
| B15 Transmission Internal Mode Switch |
The switch has 5 contacts which close in a specific sequence depending on the position of the selector lever. An additional contact generates a P/N signal for the engine control module. |
| K71 Transmission Control Module |
The control module K71 uses the information from the sensor signal B15 to determine what transmission gear range the vehicle operator selected.The control module contains a microprocessor used to process input data to control outputs. |