LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 8L45 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0960, P0962-P0964, P0966-P0968, P0970, P0971, P2670, P2671, P2736, P2738, P2739, P2812, P2814, P2815, P2824, P2826, or P2827 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine - Running
  2. Verify the scan tool parameter:
    • High Side Driver 2 Circuit High Voltage Test Status = OK or Not Run
    • High Side Driver 2 Circuit Low Voltage Test Status = OK or Not Run
    • High Side Driver 2 Circuit Open Test Status = OK or Not Run
    • Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit High Voltage Test Status = OK or Not Run
    • Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit Low Voltage Test Status = OK or Not Run
    • Transmission Control Solenoid Valve 1, 2, 3, 6, 7, 9 Control Circuit Open Test Status = OK or Not Run
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.
scientia non olet · About LEMON Manuals