Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the condition does not exist: Incorrect fluid level or condition - Refer to: Transmission Fluid Level and Condition Check
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Ignition - On/Vehicle - In Service Mode
Clear DTCs
Road test the vehicle. - Refer to: Road Test
Verify that no DTC listed in the DTC Descriptor Category is set.
- If any DTC listed in the DTC Descriptor Category is set
  Refer to: Diagnostic Fault Information
- Go to next step: If no DTC is set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify that no DTC listed in the DTC Descriptor Category is set.
- If any other DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- If any DTC listed in the DTC Descriptor Category is set
  Refer to: Diagnostic Fault Information
- Go to next step: If no DTC is set
All OK.