Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the condition does not exist: Incorrect fluid level or condition - Refer to: Transmission Fluid Level and Condition Check
- If a condition exists
  Repair or replace as necessary
- Go to next step: If no condition exists
Ignition - On/Vehicle - In Service Mode
Clear DTCs
Road test the vehicle. - Refer to: Road Test
Verify that no DTC listed in the DTC Descriptor Category is set.
- If any DTC listed in the DTC Descriptor Category is set
  Refer to: Diagnostic Fault Information
- Go to next step: If none of the DTCs listed in the DTC Descriptor Category is set
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify that no DTC listed in the DTC Descriptor Category is set.
- If any other DTCs are set
  Refer to: Diagnostic Trouble Code (DTC) List - Vehicle
- If any DTC listed in the DTC Descriptor Category is set
  Refer to: Diagnostic Fault Information
- Go to next step: If no DTC is set
All OK.