LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Automatic Transmission - 8L45 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0658, P0659, P2718, P2720, P2721, P2727, P2729, P2730, P281B, P281D, or P281E >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.

Static Test

  1. Ignition/Vehicle - Off
  2. Disconnect the appropriate electrical connector: Q77 Transmission Control Solenoid Valve
    3. NOTE:

    The component's temperature should be 19 to 21°C (66 to 70°F) while testing.

  3. Test for the resistance listed below between the test points: Control terminal 1 & Control terminal 2
    • Q77 Transmission Control Solenoid Valve - 4, 5 = 4.5 to 5.5 ohms
    • Q77H Transmission Control Solenoid Valve 8 = 11.0 to 13.0 ohms
    • If the resistance is not within range 

      Replace the appropriate component: Q77 Transmission Control Solenoid Valve

    • Go to next step: If the resistance is within range 
  4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing - Q77 Transmission Control Solenoid Valve
    • If less than infinite resistance 

      Replace the appropriate component: Q77 Transmission Control Solenoid Valve

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals