LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Road Test >> Part Throttle Step-In Downshifts

Part Throttle Step-In Downshifts

WARNING: This page is about a different variant/trim than selected.
  1. Place the gear selector in the DRIVE position.
  2. Accelerate the vehicle at light throttle (5 - 15 percent) until 3rd gear is just achieved.
  3. Quickly increase throttle angle until commanded gear indicates that a downshift to 2nd gear is commanded.
  4. Verify that the transmission downshifts within 2 seconds of the throttle movement.
  5. Repeat steps 2 to 4 at higher speed to achieve 4th gear and then step in to command a 4th gear to 3rd gear downshift.
  6. Repeat steps 2 to 4 at higher speed to achieve 5th gear and then step in to command a 5th to 4th gear downshift.
  7. Repeat steps 2 to 4 at higher speed to achieve 6th gear and then step in to command a 6th gear to 5th gear downshift.
  8. Repeat steps 2 to 4 at higher speed to achieve 7th gear and then step in to command a 7th gear to 6th gear downshift.
  9. Repeat steps 2 to 4 at higher speed to achieve 8th gear and then step in to command a 8th gear to 7th gear downshift.
  10. Repeat steps 2 to 4 at higher speed to achieve 9th gear and then step in to command a 9th gear to 8th gear downshift.
  11. Repeat steps 2 to 4 at higher speed to achieve 10th gear and then step in to command a 10th gear to 9th gear downshift.
  12. Note any harsh, soft or delayed shifts or slipping. Note any noise or vibration.