LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0711-P0713 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Remove the component: Automatic Transmission Fluid Pan
  3. Remove the component: Control Valve Assembly
  4. Disconnect the electrical connector: B13 Transmission Fluid Temperature Sensor
  5. Test for 20 to 200, 000 ohms between the test points: Signal terminal 2 & Low Reference terminal 1
    • If not between 20 and 200, 000 ohms 

      Replace the component: B13 Transmission Fluid Temperature Sensor

    • Go to next step: If between 20 and 200, 000 ohms 
  6. Verify the value is within the range listed in the table: Temperature Versus Resistance
    • If not in the specified range 

      Replace the component: B13 Transmission Fluid Temperature Sensor

    • Go to next step: If in the specified range 
  7. All OK.
scientia non olet · About LEMON Manuals