LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0658, P0659, P2812, P2814, P2815, P281B, P281D, or P281E >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine - Running
  2. Verify the scan tool parameter:
    • High Side Driver 1 Circuit Open Test Status = Not Run or OK
    • High Side Driver 1 Circuit Low Voltage Test Status = Not Run or OK
    • High Side Driver 1 Circuit High Voltage Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 7, 8 Control Circuit Open Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 7, 8 Control Circuit Low Voltage Test Status = Not Run or OK
    • Transmission Control Solenoid Valve 7, 8 Control Circuit High Voltage Test Status = Not Run or OK
    • If not the specified state 

      Refer to: Circuit/System Testing

    • Go to next step: If the specified state 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to: Circuit/System Testing

    • Go to next step: If the DTC is not set 
  4. All OK.