Circuit/System Testing

• If the test lamp does not turn On and the circuit fuse is OK 

1. Ignition/Vehicle - Off & Remove - Test lamp
2. Test for less than 2 ohms between the test points: Ignition circuit terminal 1 & Output terminal@F63UA Fuse
   • If 2 ohms or greater - Repair the open/high resistance in the circuit.
   • If less than 2 ohms - Verify the fuse is OK and there is voltage at the fuse.

• If the test lamp does not turn On and the circuit fuse is open 

1. Ignition/Vehicle - Off & Remove - Test lamp
2. Connect the electrical connector: Q83 Valve Lifter Oil Solenoid Valve
3. Ignition - On/Vehicle - In Service Mode
4. Replace the component: F63UA Fuse
5. Verify the fuse does not open.
   • If the fuse opens and there are components connected to the circuit - Disconnect a component and repeat procedure starting at step 4.4
   • If the fuse opens with all components disconnected from the circuit - Repair the short to ground on the circuit.
   • If the fuse does not open after disconnecting a component from the circuit - Replace the component disconnected last.
   • Go to next step: If the fuse does not open with all components connected.
NOTE:

It may be necessary to use a scan tool control function to operate a component.

6. Operate the component: Each component on the circuit - One at a time - Except the following component: Q83 Valve Lifter Oil Solenoid Valve

   Verify the fuse does not open when any of the components are activated.

   • If the fuse opens - Replace the component that caused the fuse to open when activated.
   • Go to next step: If the fuse does not open.
7. Refer to: Component Testing - Dynamic Test

• Go to next step: If the test lamp turns On 

• If the test lamp turns On 

1. Ignition/Vehicle - Off & Remove - Test lamp
2. Disconnect the appropriate electrical connector: K20 Engine Control Module
3. Test for infinite resistance between the test points: Control circuit terminal 2@Component harness & Ground
   • If less than infinite resistance - Repair the short to ground on the circuit.
   • If infinite resistance - Replace the component: K20 Engine Control Module

• Go to next step: If the test lamp does not turn On 

• If 5.6 V or less 

1. Ignition/Vehicle - Off
2. Disconnect the appropriate electrical connector: K20 Engine Control Module
3. Test for less than 2 ohms between the test points: Control circuit terminal 2@Component harness & The other end of the circuit
   • If 2 ohms or greater - Repair the open/high resistance in the circuit.
   • If less than 2 ohms - Replace the component: K20 Engine Control Module

• If greater than 6.2 V 

1. Ignition/Vehicle - Off
2. Disconnect the appropriate electrical connector: K20 Engine Control Module
3. Ignition - On/Vehicle - In Service Mode
4. Test for less than 1 V between the test points: Control circuit terminal 2@Component harness & Ground
   • If 1 V or greater - Repair the short to voltage on the circuit.
   • If less than 1 V - Replace the component: K20 Engine Control Module

• Go to next step: If between 5.6 and 6.2 V 

Verify the procedure/test passes.

• If the procedure/test does not pass 

  Replace the component: Q83 Valve Lifter Oil Solenoid Valve

• Go to next step: If the procedure/test passes