Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs related to the following system/component = Not Set
- B23 Camshaft Position Sensor
- B34 Engine Coolant Temperature Sensor
- B52 Heated Oxygen Sensor
- B66 Intake Air Temperature Sensor
- B74 Manifold Absolute Pressure Sensor
- B75C Multifunction Intake Air Sensor
- Q17 Fuel Injector
- Q38 Throttle Body
- Engine Misfire
- Evaporative Emission (EVAP) System
- Fuel Trim System
- ECT Sensor = Warmer than -20°C (-4°F)
- Engine Speed = 1, 200 to 4, 279 RPM
- Evaporative Emission (EVAP) Purge System = Inactive
- Fuel Control Loop Status = Closed Loop
- Fuel Level Sensor = Greater than 10%
- Ignition Voltage = Greater than 10 V
- MAF Sensor = 0 to 1, 000 g/s
Frequency the DTC runs = Once - Per ignition cycle - After the running conditions are met