LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 23 (Engine Controls And Fuel - 3.6L - Diagnostic Information And Procedures (2 Of 2)) >> Diagnostic Information and Procedures >> DTC P2096-P2099 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On/Vehicle - In Service Mode
  2. Verify there are no DTCs set related to the following component/system:
    • B23 Camshaft Position Sensor
    • B34 Engine Coolant Temperature Sensor
    • B52 Heated Oxygen Sensor
    • B74 Manifold Absolute Pressure Sensor
    • B75C Multifunction Intake Air Sensor
    • B150 Fuel Tank Pressure Sensor
    • B198 Fuel Composition Sensor
    • Q12 Evaporative Emission Purge Solenoid Valve
    • Q17 Fuel Injector
    • Evaporative Emission (EVAP) System
    • Engine Misfire
    • Go to next step: If a related DTC is not set 
  3. Verify the following conditions do not exist:
    • If a condition exists 

      Repair or replace as necessary

    • Go to next step: If no condition exists 
  4. Verify a condition does not exist with the component: B52 Heated Oxygen Sensor

    Loose/Poor Connection/Visible Damage

    • If a condition exists 

      Repair or replace as necessary

    • Go to next step: If no condition exists 
  5. Verify a condition does not exist with the component: Exhaust System

    Leaking/Loose Clamps/Missing components/Restrictions/Visible Damage

    • If a condition exists 

      Repair or replace as necessary

    • Go to next step: If no condition exists 
  6. Verify a condition does not exist with the component: Catalytic Converter
    • A rattling sound indicates internal damage.
    • Cracks or holes in the catalytic converter housing.
    • Restrictions/Visible Damage
    • Severe discoloration caused by excessive temperatures
    • If a condition exists 

      Replace the component: Catalytic Converter

    • Go to next step: If no condition exists 
  7. All OK.