LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Controls And Fuel - 2.0L - Diagnostic Information And Procedures (2 Of 3)) >> Diagnostic Information and Procedures >> DTC P0496 >> Circuit/System Description

Circuit/System Description

WARNING: This page is about a different variant/trim than selected.

For an overview of the component/system, refer to: Evaporative Emission Control System Description

Component Description
B150 Fuel Tank Pressure Sensor The pressure sensor is a 3 wire piezo-resistive pressure transducer.
The sensor measures the pressure in the component: Fuel Tank
K20 Engine Control Module The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly.

This diagnostic tests for undesired intake manifold vacuum flow to the Evaporative Emission (EVAP) System. The control module seals the EVAP system by commanding the EVAP purge solenoid valve off and the EVAP canister vent solenoid valve on. The control module monitors the fuel tank pressure (FTP) sensor to determine if a vacuum is being drawn on the EVAP system. If vacuum in the EVAP system is more or less than a predetermined value within a predetermined time, a DTC sets.

scientia non olet · About LEMON Manuals