LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Controls And Fuel - 3.6L - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P0089, P00C6, P228C, P228D, or P2C1E-P2C20 >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition/Vehicle - Off
  2. Disconnect the electrical connector: G18 High Pressure Fuel Pump
    3. NOTE:

    The component's temperature should be 24 to 26°C (75 to 79°F) while testing.

  3. Test for 9 to 13 ohms between the test points: Control terminal 1 & Control terminal 2
    • If not between 9 and 13 ohms 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If between 9 and 13 ohms 
  4. Test for infinite resistance between the test points: Each terminal of the component & The component's housing
    • If less than infinite resistance 

      Replace the component: G18 High Pressure Fuel Pump

    • Go to next step: If infinite resistance 
  5. All OK.
scientia non olet · About LEMON Manuals