LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Engine Controls And Fuel - 3.6L - Diagnostic Information And Procedures (1 Of 2)) >> Diagnostic Information and Procedures >> DTC P0068, P0101, P0106, P0121, P0236, or P1101 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P0068, P1101 

The following scan tool parameters are not within a calibrated range of the calculated air flow, which is based on throttle position:

P0101 Condition 1 

The ratio between the measured and estimated mass air flow is too low - For greater than 1 s

Condition 2 

The ratio between the measured and estimated mass air flow is too high - For greater than 1 s

P0106, P0121 

Signal Stuck In Rangeor Calculated Air Flow - For greater than 1 s

scientia non olet · About LEMON Manuals