Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P0030, P0031, P0032, P0036, P0037, P0038, P0050, P0051, P0052, P0056, P0057, P0058
- Engine Speed = Greater than 400 RPM
- Ignition On - Engine Running
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 7 s
P0053, P0054, P0059, P0060
- DTCs related to the following system/component = Not Set
- B34 Engine Coolant Temperature Sensor
- B75C Multifunction Intake Air Sensor
- ECT Sensor = Warmer than -30°C (-22°F)
- ECT Sensor & Intake Air Temperature = Within 8°C (14°F) of each other
- Engine = Running
- Ignition Off = Greater than 8 h
Frequency the DTC runs = Once - Per cold start-up - After the running conditions are met
P0135, P0141
- DTCs related to the following system/component = Not Set
- B34 Engine Coolant Temperature Sensor
- HO2S Heater = Device controls are not active.
- HO2S Heater = Greater than 0% Duty Cycle
- Ignition Voltage = Greater than 10 V
Frequency the DTC runs = 2 times - Per drive cycle - After the running conditions are met - For greater than 120 s
P0155, P0161
- DTCs related to the following system/component = Not Set
- B34 Engine Coolant Temperature Sensor
- HO2S Heater = Device controls are not active.
- HO2S Heater = Greater than 0% Duty Cycle
- Ignition Voltage = Greater than 10 V
Frequency the DTC runs = 1 times - Per drive cycle - After the running conditions are met - For greater than 120 s
P103B, P103C
- Engine = Running
- Ignition Voltage = Greater than 11 V
Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 3 s