Conditions for Running the DTC

P0089, P228C, P228D

• DTC P0016, P0017, P0018, P0019, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0116, P0117, P0118, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P0628, P1682 = Not set
• BARO = Greater than 70 kPa (10.2 PSI)
• Engine = Running
• Fuel Pressure Sensor = Greater than 300 kPa (43.5 PSI)
• Fuel Temperature = -12 to 132°C (10 to 270°F)
• IAT Sensor = Warmer than -20°C (-4°F)
• Ignition Voltage = Greater than 11 V

Frequency the DTC runs = Continuously - After the running conditions are met - For greater than 10 s

P00C6

• DTC P0090, P0091, P0092, P00C8, P00C9, P00CA, P0116, P0117, P0118, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P0628, P1682 = Not set
• BARO = Greater than 70 kPa (10.2 PSI)
• ECT Sensor = -42 to 132°C (-44 to 270°F)
• Engine = Not Running
• Fuel Pressure Sensor = Greater than 0 kPa (0 PSI)
• IAT Sensor = Warmer than -20°C (-4°F)
• Run/Crank = Greater than 8 V

Frequency the DTC runs = Continuously - After the running conditions are met

P2C1E, P2C1F, P2C20

• DTC P0016, P0017, P0018, P0019, P0090, P0091, P0092, P00C8, P00C9, P00CA, P0111, P0112, P0113, P0116, P0117, P0118, P0128, P0192, P0193, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, P0391, P0627, P0628, P0629, P111E, P127C, P128A, P128B, P128F, P1682, P16E4, P16E5 = Not set
• BARO = Greater than 70 kPa (10.2 PSI)
• Fuel Pressure Sensor = Greater than 300 kPa (43.5 PSI)
• Fuel Rail Pressure Sensor Learn Inhibit - Engine In Catalyst Warm-Up Mode = No
• Fuel Temperature = -12 to 132°C (10 to 270°F)
• IAT Sensor = Warmer than -20°C (-4°F)
• Ignition Voltage = Greater than 11 V