Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
The new replacement wiring harness may not have electrical connector (2). It will be a one piece harness.
NOTE:Be sure to remove any labels used to mark and identify the connectors during removal.
Install automatic transmission control wiring harness (4).
- If necessary, install the control valve body to the transmission. Control Valve Body Replacement
- Connect the wiring harness clips to the valve body and case.
- Connect the transmission control wiring harness connectors.
- If equipped, ensure the valve body connector retainer (3) is latched.
Install the NEW transmission fluid filter (4). Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .