LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transmission - 8L45 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Wiring Harness Replacement (Electrical Connector Passage Sleeve) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the control valve body. Control Valve Body Replacement .
  2. Disconnect the chassis wiring harness from the transmission electrical connector.
  3. GM3802143Courtesy of GENERAL MOTORS COMPANY

    Disconnect the electrical connector (1).

  4. GM3802175Courtesy of GENERAL MOTORS COMPANY

    Using a flat-bladed tool, press inward the four retaining tabs (1) around the main connector, then slide the main connector (2) inward into the transmission case.

  5. Remove the automatic transmission wiring harness from the transmission.
scientia non olet · About LEMON Manuals