LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transmission - 8L45 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM6014928Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Range Selector Lever (5) - Remove - Automatic Transmission Range Selector Lever Replacement 

  2. GM6015193Courtesy of GENERAL MOTORS COMPANY

    Remove the automatic transmission range selector lever cable retainer bracket bolt (1) and remove the automatic transmission range selector lever cable bracket (2).

  3. Remove the automatic transmission range selector lever cable from the automatic transmission range selector lever cable bracket.
  4. Remove the 2 automatic transmission range selector lever cable retainer bolts (3) from the transmission crossmember.
  5. GM5214983Courtesy of GENERAL MOTORS COMPANY

    Remove the automatic transmission range selector lever cable guide nut (1).

  6. Front Floor Lower Console Replacement - Remove
  7. GM4535116Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Mark the orientation of the grommet to the floor panel for installation.

    Remove the grommet and cable (1) from the floor panel.

  8. Remove the automatic transmission range selector lever cable bracket bolt (3).
  9. Slide the automatic transmission range selector lever cable retainer rearward (5) and remove the automatic transmission range selector lever cable from the transmission control base.
  10. Disconnect the automatic transmission range selector lever cable terminal (6) from the shift lever pin (7).
  11. Remove the automatic transmission range selector lever cable (2) from the vehicle.
scientia non olet · About LEMON Manuals