LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Automatic Transmission - 10L60, 10L80 Or 10L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4535116Courtesy of GENERAL MOTORS COMPANY

    Install the automatic transmission range selector lever cable (2) into the vehicle.

  2. Connect the automatic transmission range selector lever cable terminal (6) to the shift lever pin (7).
  3. Install the automatic transmission range selector lever cable (2) to the transmission control base by pressing down until it seats into place.
  4. Slide the automatic transmission range selector lever cable retainer forward (5).
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the automatic transmission range selector lever cable bracket bolt (3) and tighten to 9 N.m (80 lb in).
    6. NOTE:

    Ensure the grommet is properly oriented.

  6. Install the grommet and automatic transmission range selector lever cable (1) into the floor panel with alignment key opening.
  7. Install the front floor console. Front Floor Console Replacement
  8. GM5214983Courtesy of GENERAL MOTORS COMPANY

    Install and tighten the automatic transmission range selector lever cable guide nut (1) to 9 N.m (80 lb in).

  9. GM6015315Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    After installing the transmission range selector shift cable, pull up and push down on ALL connections to verify that the connections are fully seated and properly engaged. Failure to perform this task can result in the vehicle not being able to shift into PARK causing potential vehicle damage and bodily injury.

    Install the 2 automatic transmission range selector lever cable retainer bolts (3) to the transmission crossmember and tighten to 9 N.m (80 lb in).

  10. Install the automatic transmission range selector lever cable into the automatic transmission range selector lever cable bracket and ensure cable is fully seated.
  11. Install the automatic transmission range selector lever cable retainer bracket (2).
  12. Install the automatic transmission range selector lever cable retainer bracket bolt (1) and tighten to 9 N.m (80 lb in).
  13. GM6014245Courtesy of GENERAL MOTORS COMPANY

    Automatic Transmission Range Selector Lever Cable Lever (5) - Install - Automatic Transmission Range Selector Lever Cable Lever Replacement 

scientia non olet · About LEMON Manuals