Connecting Rod Bearing Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- NOTE:
If the connecting rod bearings have been used in a running engine, you must replace them with NEW connecting rod bearings for reassembly.
Clean the connecting rod (2) and the connecting rod cap bearing bore with a lint-free cloth.
- Clean all the oil from behind the connecting rod bearing halves.
- Install NEW upper connecting rod bearing (1) into position. Roll the bearing into position so that the lock tang engages the alignment slot. The bearing must fit flush in the connecting rod.
- Install the EN-46121 Connecting Rod Guide Pin Set into the connecting rod bolt holes.
Install NEW lower connecting rod bearing (1) into position in the connecting rod cap (2). Roll the bearing into position so that the lock tang engages the alignment slot. The bearings must fit flush with the connecting rod cap.