LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L - Repair Instructions) >> Repair Instructions >> Intake Manifold Overhaul >> Assemble Procedure

Assemble Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM3961538Courtesy of GENERAL MOTORS COMPANY

    Intake Manifold Seal (1) - Install NEW

  2. Manifold Absolute Pressure Sensor (2) - Install
    3. CAUTION:

    Refer to Fastener Caution .

  3. Manifold Absolute Pressure Sensor Bolt (3) - Install and tighten 4 N.m (35 lb in)
  4. Evaporative Emission Canister Purge Solenoid Valve (4) - Install and tighten 10 N.m (89 lb in)
  5. Throttle Body Gasket (5) - Install NEW
  6. Throttle Body (6) - Install
  7. Throttle Body Bolt (7) - Install and tighten [4x] 10 N.m (89 lb in)
  8. Intake Manifold Insulator (8) - Install
  9. Intake Manifold Insulator Retainer (9) - Install and tighten [4x] 10 N.m (89 lb in)
scientia non olet · About LEMON Manuals