LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L - Repair Instructions) >> Repair Instructions >> Engine Block Overhaul >> Measuring Cylinder Bore Taper

Measuring Cylinder Bore Taper

WARNING: This page is about a different variant/trim than selected.
  1. Measure the cylinder bore along the thrust surfaces, perpendicular to the crankshaft centerline, at 10 mm (0.397 in) below the deck surface and record your measurement.
  2. Measure the cylinder bore along the thrust surfaces, perpendicular to the crankshaft centerline, at 100 mm (3.976 in) below the deck surface and record your measurement.
  3. Calculate the difference between the 2 measurements. The result will be the cylinder taper.
  4. Compare your results with the Engine Mechanical Specifications . If the cylinders exceed the specifications, the engine block may be oversized to 0.25 mm (0.010 in). There is only one size of oversized pistons and rings available for service.
scientia non olet · About LEMON Manuals