LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2023 >> Camaro ZL1, 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical - 3.6L - Repair Instructions) >> Repair Instructions >> Engine Block Overhaul >> Disassemble Procedure

Disassemble Procedure

WARNING: This page is about a different variant/trim than selected.
  1. GM4066051Courtesy of GENERAL MOTORS COMPANY

    Engine Block Oil Gallery Plug Cap (1) - Remove [2x]

  2. Engine Block Oil Gallery PlugM16 (2) - Remove [2x]
  3. Cylinder Head Locating Pin (3) - Remove [2x]
  4. Knock Sensor Bolt (4) - Remove
  5. Knock Sensor (5) - Remove
  6. Engine Oil Pressure Sensor (6) - Remove
  7. Engine Block Core Hole Plug (7) - Remove
  8. Engine Block Oil Gallery PlugM16 (8) - Remove
  9. Piston Oil Nozzle Bolt (9) - Remove [3x]
  10. Piston Oil Nozzle (10) - Remove [3x]
  11. Engine Front Cover Stud (11) - Remove [3x]
  12. GM4066056Courtesy of GENERAL MOTORS COMPANY

    Cylinder Head Locating Pin (1) - Remove [2x]

  13. Engine Block Core Hole Plug (2) - Remove
  14. Crankshaft Position Sensor Bolt (3) - Remove
  15. Crankshaft Position Sensor (4) - Remove
  16. Knock Sensor Bolt (5) - Remove
  17. Knock Sensor (6) - Remove
  18. Knock Sensor Heat Shield Bolt (7) - Remove [2x]
  19. Knock Sensor Heat Shield (8) - Remove
  20. Engine Block Oil Gallery PlugM16 (9) - Remove
  21. Engine Coolant Temperature Sensor (10) - Remove
  22. Crankshaft Rear Oil Seal Housing Locating Pin (11) - Remove [2x]
  23. Engine Block Oil Gallery PlugM16 (12) - Remove [2x]
scientia non olet · About LEMON Manuals