Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Camshaft Timing Chain-Right Side - Remove - Camshaft Timing Chain Assembly Replacement - Right Side
Fuel Injection Fuel Rail Noise Shield (1) - Remove - Fuel Injection Fuel Rail Noise Shield Replacement
Warm Up Three-Way Catalytic Converter (3) @Bank 1 - Remove - Warm Up Three-Way Catalytic Converter Replacement (LH - LGX)Warm Up Three-Way Catalytic Converter Replacement (RH - LGX)
- Fuel Pump - Remove - Fuel Pump Replacement
- Remove the ground wire bolt and ground wire.
- Disconnect and reposition harness as necessary.
- Camshaft-Right Side - Remove - Camshaft Replacement - Right Side
Camshaft Carrier-Right Side (2) - Remove - Camshaft Carrier Resealing - Right Side
Valve Lifter-Right Side - Remove - Valve Lifter Replacement - Right Side
Cylinder Head Bolt (1) - Remove and DISCARD [8x]
- Remove and DISCARD the rear M8 right cylinder head bolt (2).
- Cylinder Head (3) - Remove
- Cylinder Head Gasket (4) - Remove and DISCARD
- Clean, inspect and overhaul the cylinder head as needed. Cylinder Head Overhaul