Oil Pump Timing Chain Installation
WARNING: This page is about a different variant/trim than selected.
- NOTE:
Timing of the oil pump to the engine is not required. The colored links on the oil pump drive chain and timing mark on the oil pump drive sprocket are for production use only.
Oil Pump Timing Chain (1) - Install
- Crankshaft Sprocket (2) - Install
- Oil Pump Sprocket (3) - Install
- Oil Pump Drive Bolt (4) - Install NEW and tighten
- First Pass: 15 N.m (11 lb ft)
- Final Pass: 110 degrees
NOTE:
Use a suitable wrench to hold the sprocket to torque the bolt.