Removal Procedure
WARNING: This page is about a different variant/trim than selected.
Camshaft Position Actuator (1) - Remove [2x] - Camshaft Position Actuator Replacement - Bank 1
Camshaft Bearing Cap Bolt (1) - Remove
- Camshaft Bearing Cap Bolt (2) - Remove [4x]
- Camshaft Bearing Cap (3) - Remove
- Dowel Pin (4) - Remove
- Camshaft Bearing Cap Bolt (5) - Remove [14x]
- Camshaft Bearing Cap (6) - Remove
- Camshaft Bearing Cap (7) - Remove
- Camshaft Bearing Cap - Intermediate (8) - Remove
- Dowel Pin (9) - Remove
- Intake Camshaft - Right Side (10) - Remove
- Exhaust Camshaft - Right Side (11) - Remove
NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 1 (B)
NOTE:
Laser Etched or ID flats- Correct Camshaft Location - Bank 1 (A)